Pbyp (Picture By Picture); Pip (Picture In Picture) - Christie LWU620i User Manual

PbyP (Picture by Picture) / PIP (Picture in Picture)
The PbyP / PIP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
PbyP
button
Press the PbyP button on the remote control. This acctivates the PbyP mode.
Then, press the PbyP button again. The projector goes into PIP mode. The
screen displayed before the PbyP button was pressed is displayed as the main
area. Most of operations are effective for the main area only. Only outputs the
audio input signal paired with the picture input signal for the main area.
To quit the PIP mode, press the PbyP button again.
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
• When in the PbyP / PIP mode, use the MENU button on the remote control or
▲/▼ buttons on the control panel to display the OSD menu.
• Some functions that cannot be used when in the PbyP / PIP mode.
• A message is displayed when buttons that cannot be used are pressed (118).
However, messages are not displayed for some unusable buttons.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
(continued on next page)
LWU720i/LHD720i/LWU620i
User's Manual - Operating Guide
ð
Normal mode
main sub
ð
area area
PbyP mode
53
Operating
main
area
sub area
PIP mode
020-001279-01 Rev. 1 (10-2017)