Rev 1.2
To extract a Fan Unit:
Grasping the handle with your hand, push the latch release with your thumb while pulling the
Step 1.
handle outward. As the fan unit unseats, the fan unit status LEDs will turn off.
Remove the fan unit.
Step 2.
To remove or replace a fan unit, gently pull out its black handle while pus
latch release with your thumb.
To insert a FAN Unit:
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Step 1.
Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue pressing
Step 2.
the fan unit until it seats completely
34
Mellanox Technologies
Figure 24: Fan Module Latches
The green Fan Status LED should light. If not, extract the fan unit and reinsert it. After
two unsuccessful attempts to install the fan unit, power off the
ing any system debug.
Installation
system
before attempt-