Printer Setup; Installing The Stacker (Option) - Avery Dennison 686 User Manual

Printer Setup

Installing the Stacker (Option)

10 • • • • Printer Setup
Remove the stacker from the separate packaging. Remove the packaging from
around the stacker and save with the rest of the printer packing supplies.
Swing open the top cover to the printer. Locate the large knob and two round pins
on the right hand side of the printer. Loosen the knob enough to allow the stacker to
slide between the printer housing and the knob. The stacker will rest on the two
pins. Slide the stacker to the back until it contacts the up-right frame. Tighten the
knob. Adjusting the stacker is covered later.
Install the stacker up-right rails. Remove one of the thumbscrews. Insert the
thumbscrew through the mating hole in the up-right rail assembly. Thread the
thumbscrew into the mounting block. Repeat the above procedure for the other
thumbscrew.
There is a cable with a connector leading from the back of the stacker that plugs into
a socket on the TCB (refer to the P.C. Board Identification section in this manual).
The socket and plug are polarized. Rotate the plug until the polarized keyway and
socket align and push the stacker connector into the socket.
Users Manual Model 686 / 686 HT