Setup Printer; Material Inserting Procedure - Avery Dennison AP7.t User Manual

07/08 Rev. 5.01-01

Material Inserting Procedure

•
•
Material print
surface outside
USER MANUAL
CAUTION! - Trained staff is required for inserting and changing ribbons and
material!
Ribbon winding direction depicted in [1] and [2]: Colour side inwards.
Ribbon rolls with the colour side facing outwards can also be used (see [3]).
Winding setup see section
page 3.
1
13 12
11
[1] Material and ribbon path in the AP 7.t when using textile material. Winding direction: Print
surface outside.
No. Operating Parts
1 Ribbon rewinding mandrel
2 Ribbon unwinding mandrel
3 Printhead pressure lever
4 Material deflection axle
5 Material pressure brush
6 Material guide plate
7 Material roll
[Table 1] Operating parts in the AP 7.t.
AP 7.t
Ribbon with the colour side facing outwards
2 3 4 5
10 9 8
No. Operating Parts
8 Material brake
9 Material guide
10 Sensor fitting
11 Printhead
12 Print roller
13 Opener for pressure roller

Setup Printer

on
6 7
2