Setting The Address - YOKOGAWA wt1600 User Manual

1.5

Setting the Address

Keys
Procedure
Explanation
IM 7601010-11E
ESC
INPUT
RANGE SCALING WIRING
MOTOR SET
FILTER AVG MEASURE
CAL
INTEGRATOR
START STOP SYNC SRC
INTEG SET RESET
1. Press MISC to display the Misc menu.
2. Press the Communication soft key.
3. Press the Comm Device soft key to display the GP-IB menu.
4. Turn the jog shuttle to set the address.
ESC
Carry out the following settings when using a controller to set information that can be
specified through key operation on the WT1600 or when outputting setting parameters or
output waveform display data to the controller.
Setting the Address
Set the address of the WT1600 within the following range for the addressable mode.
0 to 30
Each device that can be connected via GP-IB has a unique address within the GP-IB
system. This address is used to distinguish the device from others. Therefore, when
you connect the WT1600 to a PC, for example, make sure to assign a unique address
to the WT1600.
Note
Do not change the address while the controller or other devices are using the GP-IB system.
UP DATE
DISPLAY HOLD FILE
RATE
SINGLE STORE SET
TRIG'D REMOTE
WAVE HARMONICS LOCAL
CURSOR
MAX HOLD
To exit the menu during operation,
press ESC.
ESC
STORE COPY
MENU
MISC
NULL
SHIFT
1-5
1