YOKOGAWA wt1600 User Manual page 153

Error in communications execution (200 to 299)
Code Message
221 Setting conflict
222 Data out of range
223 Too much data
224 Illegal parameter value
241 Hardware missing
260 Expression error
270 Macro error
272 Macro execution error
273 Illegal macro label
275 Macro definition too long
276 Macro recursion error
277 Macro redefinition not allowed
278 Macro header not found
Error in communications Query (400 to 499)
Code Message
410 Query INTERRUPTED
420 Query UNTERMINATED
430 Query DEADLOCKED
440 Query UNTERMINATED after
indefinite response
Error in System Operation (912 to 914)
Code Message
912 Fatal error in Communications-
driver
Warning
Code Message
*OPC/? exists in message
5
Other errors (350 and 390)
Code Message
350 Queue overflow
390 Overrun error
(only Serial(RS-232))
IM 760101-11E
Action
Check the relevant setting.
Check the setting range.
Check the data byte length.
Check the setting range.
Check availability of options.
Equation is not allowed.
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Does not conform to the macro function specified in IEEE488.2. —
Action
Check transmission/reception order.
Check transmission/reception order.
Limit the length of the program message including
<PMT> to 1024 bytes or less.
Do not enter any query after *IDN? and *OPT?.
Action
Servicing is required.
Action
Place the *OPC or *OPC? at the end of the program message.
Action
Read the error queue. Code 350 occurs when the error queue
is full up. This message is output only for the STATus:ERRor?
query and is not displayed on the screen.
Execute with a lower baud rate.
Note
Code 350 indicates overflow of error queue. This code is returned as a response to the
"STATus:ERRor?" query; it does not appear on the screen.
Appendix 2 Error Messages
Reference Page
Chapter 5
Chapter 5
Chapter 5
Chapter 5
—
—
Reference Page
4-2
4-2
4-2
—
Reference Page
—
Reference Page
—
Reference Page
6-5
—
App-3
App