Introduction - GE Druck ADTS 505 User Manual

i

Introduction

This technical manual provides operating instructions for the Air Data Test System compatible

with the requirements of first line operation for the technician and supervisor.
Scope
This technical manual contains a brief description, operation and testing procedures for the

user of this equipment with software version V1.08.
Safety
The manufacturer has designed this equipment to be safe when operated using the

procedures detailed in this manual. Do not use this equipment for any other purpose than that
stated, the protection provided by the equipment may be impaired.
This publication contains operating and safety instructions that must be followed to make sure

of safe operation and to maintain the equipment in a safe condition. The safety instructions are
either warnings or cautions issued to protect the user and the equipment from injury or
damage.
Use qualified* technicians and good engineering practice for all procedures in this publication.

PIN Protection
The ADTS 505 contains two protected menus, the operating limits (described in this manual)
and the maintain calibration menu (described in the calibration manual).
The factory set PIN codes are contained in an envelope addressed to the Supervisor.
Change these codes for authorised access. Unauthorised access to these two menus can make
this system inaccurate and could, in control mode, cause excessive rates of pressure change.
Pressure
Do not apply pressure greater than the maximum safe working pressure to the equipment.

Toxic Materials
There are no known toxic materials used in this equipment.
Maintenance
The equipment must be maintained using the manufacturer's procedures and should be

carried out by authorized service agents or the manufacturer's service departments
Technical Advice
For technical advice contact the manufacturer or subsidiary.

* A qualified technician must have the necessary technical knowledge, documentation, special test
equipment and tools to carry out the required work on this equipment.
I
MPORTANT NOTE
K0260 Issue No. 8