Adjusting The Track Width (Additional Adjustment) - Otto Bock Voyager Evo Instructions For Use Manual

3
5

6.2.2 Adjusting the track width (additional adjustment)

The camber modules can slide in the axle for adjusting the track width horizontally (see fig. 7, item 1) .
In case of camber modules with a screwed-in fitting, the counter nut on the fitting also has to be loosened and the
fitting adjusted to the desired length.
Adjustment on camber module for quick-release axles Ø 12 mm
1) Remove the wheels.
2) Loosen the Allen head screw respectively on the seat clamp (see fig. 8).
3) Loosen the Allen head screw respectively on the axle tube clamp (see fig. 9).
NOTE: The adjustment should be made on one side first and then on the other.
NOTE: The track width must be adjusted symmetrically on both sides. Set the track width so that the
slanted rear wheels run freely.
4) Insert the rear wheel's quick-release axle into the camber module to aid removal (see fig. 10).
5) Move the camber module to the desired position outwards with the aid of the quick-release axle or inwards with
the help of a soft-faced hammer.
→ Do not pull the camber module out too far. During installation the whole camber module must be fully
enclosed by the axle tube clamp.
→ Check the position by measuring it afterwards. To do this, measure the distance between the outer side of
the camber module and the outer side of the axle tube clamp.
6) Lightly clamp the camber module in the axle tube clamp.
7) Adjust the track width in the same fashion on the other side. Make sure that both camber modules have been
adjusted symmetrically.
8) Make the track adjustments (see Page 13).
9) Tighten the Allen head screw respectively on the axle tube clamps to 15 Nm (see fig. 9).
10) Tighten the Allen head screw respectively on the seat clamps to 7 Nm (see fig. 8).
Voyager Evo
4
6
Settings
Ottobock | 11