Adjusting The Seat And Back Support Width; Adjusting The Forearm Supports; Adjusting The Pads - Otto Bock C1000 SF Instructions For Use Manual

1

6.4 Adjusting the seat and back support width

The seat and back width are adjusted by turning the supports in the connecting piece (see Page 11 ff.). There is a
setting range of ±40 mm on each side.

6.5 Adjusting the forearm supports

CAUTION
Reaching into swivel region
Pinching or crushing of limbs (e.g. fingers) due to lack of caution in danger areas
► Do not reach into the swivel region.
The height and depth of the armrests can be adapted to the requirements of the user.
2
3

6.6 Adjusting the pads

The position of the supports (optional) can be adapted to the requirements of the user.
C1000 SF
Adjusting the back support
1) Loosen the 4 screw connections on the back plate
(see fig. 1).
2) Slide the back support up or down in the slotted
holes.
3) Retighten the 4 screws.
Adjusting the height
To adapt the arm supports to the upper arm length of
the user, the corresponding mounting hole on the rear
of the back support has to be selected:
1) Loosen the two screws that attach the arm support
to the back support (see fig. 2).
2) Remove the arm support.
3) Match the arm support's mounting position with
another mounting hole and retighten the screws.
Adjusting the position
To adapt the arm support to the forearm length of the
user, the screw connections on the underside of the
arm support must be changed:
1) Loosen the two screws on the underside of the arm
support (see fig. 3).
2) Move the arm support with the control panel holder
or replacement tube forward or backwards along
the attachment rail to the desired position.
3) Retighten the two screws.
Settings
11