Adjusting The Back/Seat Upholstery; Adjusting The Back Upholstery - Otto Bock Voyager Evo Instructions For Use Manual

Adjustment of a back assembly with back plate
The back angle is continuously adjustable by up to 15°.
1) On both sides, loosen all Allen head screws on the back plate (see fig. 22).
2) Move the back plate to the desired angle (see fig. 23).
NOTE: Please note that the back height can now be adjusted as well (see fig. 22).
3) On both sides, tighten the Allen head screws to 8 Nm (see fig. 22).
Adjustment of a back assembly with back upholstery
The back angle cannot be changed afterwards.
23
Adjusting the fold-down back
1) Lift off the side panels.
2) Fold the backrest forward to the first locking position.
3) Loosen the Allen head screw on the adjustment bores on both sides (see fig. 24).
4) Set the new position (see fig. 25).
5) Tighten the Allen head screws (spanner width 4) on both sides to 7 Nm.
24

6.6 Adjusting the Back/Seat Upholstery

6.6.1 Adjusting the Back Upholstery

INFORMATION
A well-adjusted backrest provides lasting comfort for the wheelchair user and reduces the risk of secondary dam­
age and pressure zones. Do not create too much pressure.
INFORMATION
Ensure that the user's pelvis is positioned as far back in the wheelchair as possible, i.e. between the backrest
tubes.
The backrest cover can be adjusted in segments to the needs of the user.
1) Remove the seat cushion.
Voyager Evo
25
Settings
Ottobock | 17