Adjusting The Track Width (Additional Adjustment) - Otto Bock Ventus Instructions For Use Manual

Adjustments
5
7

6.2.3 Adjusting the track width (additional adjustment)

The 0° and 3° camber modules (see fig. 13, item 1) can slide in the clamping flange for adjusting the track width.
With the 6° and 9° camber modules (see fig. 13, item 2), the track is changed by adjusting the screwed in fitting
(see fig. 12, item 1).
Adjustment of Camber Module 0°/3°
1) Remove the wheels.
2) Place the wheelchair upside down.
3) Loosen the clamping screw on the clamping flange (see fig. 9, item 1).
NOTE: The adjustment must be made on one side first and then on the other.
NOTE: The track width must be adjusted symmetrically on both sides.
4) Insert the rear wheel's quick-release axle into the camber module to aid removal (see fig. 10, item 1).
5) Move the camber module (see fig. 10, item 2) to the desired position outwards with the aid of the quick-release
axle or inwards with the help of a soft-faced hammer.
→ Do not pull the camber module out too far. During installation the whole camber module must be fully
enclosed by the clamp fitting.
→ Check the position by measuring it afterwards (see fig. 11).
6) Clamp the camber module lightly using the clamping screw on the clamping flange.
7) Adjust the track width in the same fashion on the other clamping flange. Make sure that both camber modules
have been adjusted symmetrically.
8) Attach the wheels.
9) Make the track adjustments (Adjusting the track).
10) Tighten the clamping screws to 10 Nm (see fig. 9, item 1).
12 | Ottobock
6
8
Ventus