Adjusting The Track Width (Additional Adjustment); Adjusting The Quick-Release Axle - Otto Bock Zenit Instructions For Use Manual

Settings
16
18

6.2.4 Adjusting the track width (additional adjustment)

INFORMATION
The adjustments described below may also be carried out the same way on the CLT model (not illustrated).
After loosening the mounting nut (see fig. 8), the position of the quick-release axle mounting can be adjusted in or
out by turning it. This allows the distance between the drive wheel and the side panel to be continuously adjusted.
Please note: Only unscrew the quick-release axle mounting so that it is still flush with the side support on the
inside.

6.2.5 Adjusting the quick-release axle

The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the quick-release axle by the head (wrench size: 19 mm) and by the tip (wrench size: 11 mm) with a ring
and open-ended wrench respectively.
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 20, item 1) in or out.
20
14
17
19
Zenit