Changing The Installation Position Of The Caster Wheels - Otto Bock Voyager Evo Instructions For Use Manual

Settings
7) Temporarily attach the bearing sleeve with caster fork in the caster wheel journal.
8) Set the caster wheel axle vertically. Check the 90° setting with a square (see fig. 12).
→ The caster wheel axles/caster wheels on both caster wheel adapters must be positioned vertically.
9) Reinstall the caster wheel assembly. When tightening the screws, note the following torque values:
→ Allen head screw on the inside (see fig. 13, item 1): 23 Nm
→ Set screw (secured with "medium" Loctite) on the outside to secure the bearing sleeve (see fig. 13,
item 2): 8 Nm
12
14

6.3.2 Changing the Installation Position of the Caster Wheels

INFORMATION
Observe the seat height table in the "Technical data".
The front seat height can be adjusted by moving the caster wheels in the fork and by selecting the caster wheel
size.
1) Unscrew the screw connection of the threaded axle (see fig. 17).
2) Remove the threaded axle/spacers.
3) Remove the caster wheel.
4) Insert the threaded axle with the first spacer bushing offset in one of the bore holes.
5) Install the caster wheel.
6) Slide on the second spacer bushing (not illustrated).
7) Tighten the threaded axle to 8 Nm.
→ Once changed, the left and right caster wheel must have the same vertical position in the caster fork.
→ Once the anterior seat height has been adjusted, the rear wheel tracking (see Page 13) and the caster wheel
journal angle (see Page 13) must be checked and adjusted if required.
14 | Ottobock
13
15
Voyager Evo