Installing / Adjusting The Tip-Assist; Delivery; Final Inspection; Transport To The Customer - Otto Bock Voyager Evo Instructions For Use Manual

Delivery

2) Adjust the length of the pivot arm.
3) Bolt down the pivot arm. The outer edge of the anti-tipper roller has to project beyond the largest diameter of
the rear wheels (see fig. 38).
Adjusting the Angle of the Pivot Arm
1) Remove the Allen head screw between the anti-tipper tube and the angle adjuster (see fig. 40, item 1).
2) Loosen the second Allen head screw on the angle adjuster (see fig. 40, item 2).
3) Set the angle of the pivot arm.
4) Bolt down the pivot arm. The max. distance between the anti-tipper rollers and floor is 50 mm (see fig. 38).
39

6.9.4 Installing / adjusting the tip-assist

The tip-assist can be installed on the accessory mount in the installation position provided (see fig. 37, item 1).
1) Press the spring on the tip-assist (not illustrated).
2) Insert the tip-assist into the accessory mount.
3) Allow the spring to lock in.
7 Delivery

7.1 Final inspection

A final check must be carried out before the wheelchair can be handed over:
• Are all options installed according to the order form?
• Have the rear wheels been correctly positioned?
• Have the tyres been correctly inflated?
INFORMATION: The correct tyre pressure is printed on the tyre sidewall. For rear wheels with high-
pressure tyres, the minimum air pressure is 7 bar.
• Has the axle assembly been fastened to the frame and tightened to the specified torque?
• Can the quick-release axles rotate freely?
• Have the brakes (wheel locks) been adjusted correctly?
• Has the caster journal angle been adjusted vertically?
• Has the anti-tipper been adjusted correctly?

7.2 Transport to the customer

The wheelchair should be transported to the user in disassembled state using the outer packaging.

7.3 Handing over the product

The following steps must be performed for the safe delivery of the product:
• Conduct a sitting test with the user of the product. Pay special attention to proper positioning according to
medical considerations.
• The user and any attendants must be instructed in the safe use of the product. In particular, the enclosed
instructions for use (user) are to be used.
• The instructions for use (user) must be issued to the user/attendant during handover of the wheelchair.
22 | Ottobock
40
Voyager Evo