Adjusting The Footrests; Adjusting The Lower Leg Length; Adjusting The Plate Angle - Otto Bock Voyager Evo Instructions For Use Manual

Hide thumbs Also See for Voyager Evo:

Table of Contents

7) Secure the seat cushion with the hook-and-loop fastener.

6.7 Adjusting the footrests

The required footrest height depends on the lower leg length of the user and the thickness of the seat cushion.

"Angle-adjustable" Footrest, "Fixed" Footrest

1) Loosen the Allen head screws above the footrest (see fig. 32, item 1).

2) Adjust the lower leg length (continuously adjustable). The footrest must be inserted at least 60 mm into the

frame tube.

3) Tighten the Allen head screws to 8 Nm.

"Angle-adjustable/Depth-adjustable" Footrest

The adjustment of this footrest can be fine-tuned as follows:

1) Loosen 2 Allen head screws respectively on each side of the footrest assembly. However, do not completely

unscrew the Allen head screws (see fig. 33, item 1).

2) After loosening the Allen head screws, pry the clamp washer out of the bore hole in the cross-tie using a suit

able tool (e.g. screwdriver). Do not remove the clamp washer entirely.

3) Push the footrest assembly up/down slightly around the pivot point (see fig. 33, item 2). Ensure that the cross-

ties are parallel before re-tightening the screws.

NOTE: During the adjustment process, never loosen the screws (see fig. 33, Fig. 1 and Fig. 3) at the

same time.

4) Tighten the Allen head screws to 10 Nm. In doing so, ensure that the clamp washer is parallel (not tilted) in the

cross-tie for optimum fixation.

INFORMATION: After each adjustment of the lower leg length, readjust the footrest angle.

The footrest setting should be chosen so that the ankle is in a relaxed, comfortable position.

"Fixed" Footrest

The angle of the footplate cannot be changed (not illustrated).

Voyager Evo

Settings

Ottobock | 19

Table of Contents