Replacing A Cf Card; Replacing A Transceiver Module - HP FlexNetwork HSR6802 Installation Manual

Figure 51 Pulling the MIM out of the slot
4. Install a new MIM. For the installation procedure, see
If you do not install a new MIM in the slot, install a filler panel.

Replacing a CF card

CAUTION:
To avoid hardware damage, do not remove the CF card when the router is booting or the CF LED is
flashing.
To replace a CF card:
1. Press the CF card eject button of the CF card reader so that the eject button projects from the
panel.
2. Press the eject button again to eject the CF card part-way out of the CF card reader, and then
pull the CF card out of the CF card reader.
Figure 52 Removing a CF card
3. Install a new CF card. For the installation procedure, see

Replacing a transceiver module

1. Pressing the tab of the LC connector, pull out the LC connector from the transceiver module.
Put on the dust cap for the LC connector.
2. Pivot the clasp of the transceiver module down to the horizontal position.
3. Hold the clasp to gently pull the transceiver module out.
"Installing a
"Installing a CF
45
MIM."
card."