Installing A Cf Card - HP A6602 Installation Manual

Figure 6-16 Pull the MIM out of the slot
After removing a MIM, place it in an antistatic bag. After removing a MIM, place it in an antistatic bag.

If you do not install a new interface module where the MIM was removed, install a blank panel If you do not install a new interface module where the MIM was removed, install a blank panel If you do not install a new interface module where the MIM was removed, install a blank panel

to prevent dust from entering the chassis.
Inserting and Removing a CF Card Inserting and Removing a CF Card

Installing a CF Card

Follow these steps to install a CF card: Follow these steps to install a CF card:
Step1 Make sure that the CF card LED is not blinking before proceeding with the next step. Make sure that the CF card LED is not blinking before proceeding with the next step. Make sure that the CF card LED is not blinking before proceeding with the next step.
Step2 Press the CF card eject button in and make sure it does not project from the panel. Press the CF card eject button
Step3 Insert the CF card into the slot and push it all the way in until it is firmly seated. Insert the CF card into the slot and push it all the way in until it is firmly seated. Insert the CF card into the slot and push it all the way in until it is firmly seated.
Figure 6-17 Insert the CF card into the slot
If the application program for booting the router is stored in an external CF card, make sure that If the application program for booting the router
the right CF card has been correctly installed in the slot; otherwise the router will fail to boot. the right CF card has been correctly installed in the slot; otherwise the router will fail to boot. the right CF card has been correctly installed in the slot; otherwise the router will fail to boot.
Removing a CF Card
Follow these steps to remove a CF card: Follow these steps to remove a CF card:
Step1 Make sure that the CF card LED is not blinking before proceeding with the next step. Make sure that the CF card LED is
Step2 Press the CF card eject button so that the eject button projects from the panel. Press the CF card eject button so that the eject button projects from the panel. Press the CF card eject button so that the eject button projects from the panel.
Pull the MIM out of the slot
ing the chassis.
in and make sure it does not project from the panel.
Insert the CF card into the slot
not blinking before proceeding with the next step.
is stored in an external CF card, make sure that