Installing The Copy Data Controller-A1; Copy Data Controller-A1 - Canon GP405 Service Manual

V. INSTALLING THE
COPY DATA
CONTROLLER-A1
1 Setting the Board
A. Copy Data Controller-A1
1) Remove the two screws [2], and detach
the upper over [1].
[2]
Figure 12-501
Switch bit Position
SW1 1 to 3 OFF
4 ON
OFF
5 ON
OFF
6 ON
OFF
SW5 1 ON
OFF
2 ON
OFF
3 ON
OFF
4 ON
OFF
5, 6 OFF
Note: If the Control Card V is used or remote control by the Copy Data Controller-A1 is used*, keep
bit 4 of the DIP switch (SW5-4) to OFF.
* If group control functions other than the following are not used: ID input, control by paper size,
control by toner color, control by copy mode, control by paper type.
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[2]
Description
For normal operation.
For IPC communication.
For serial communication.
If a central control device is used.
For normal operation, or for remote
control using a commercially
available modem.
For RAM initialization.
For normal operation.
For factory adjustment.
For normal operation.
For control of Inch-configuration
(11x17, LTR, LGL, STMT).
For control of AB-configuration
(A3, A4, B4, B5).
For service mode.
For normal operation.
If group control is planned.
If group control is not planned.
Not used.
CHAPTER 12 INSTALLATION
2) Set the DIP switches (SW1, SW5) to suit
the needs of the user.
2-1) Shift bit 4 of the DIP switch (SW1-4) to
match the copier model.
2-2) If group control is planned, shift bit 2 of
the DIP switch (SW5-2).
To control AB-configuration paper,
(A3, A4, B4, B5), keep it to OFF.
To control Inch-configuration paper
(11x17, LTR, LGL, STMT), keep it to
ON.
CL700/800, NP6750, NP6016, GP
Series
NP6030, NP6060, NP8530, NP9800
Requires an Interface Board-B1.
Remote control using a commercially
available modem requires a modem
and an Interface Board-B1.
For other paper types, use service
mode under 10) of 5. "Checking the
Operation."
See Note.
Remarks
12-33