Canon GP405 Service Manual page 218

CHAPTER 7 PICK-UP/FEEDING SYSTEM
2. Removing the Multifeeder Pick-Up
Roller
1) Pull out the roll [1] of the multifeeder
cover.
2) Free the cable from the hook [3]; then,
detach the right door [2].
Figure 7-216
3) Remove the snap-on bushing [2], and shift
the roller shaft [3] in the direction of the
arrow.
4) Remove the stop shaft [4], and remove the
multifeeder pick-up roller [5].
Caution:
1. Take care not to drop the pin fitted at
the rear of the multifeeder pick-up
roller.
2. Take care not to deform the
grounding plate found at the rear of
the roller shaft.
[2] [3]
Figure 7-217
7-56
Roll
[1]
[3]
[2]
[4] [5]
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
3. Removing the Separation Pad
1) Remove the right door.
2) Remove the multifeeder pick-up roller.
3) While pushing the end [1] of the right
door in the direction of A, move the rear
of the separation pad cover [2] in the
direction of B to remove.
[2]
Figure 7-218
4) Free the hook [4] of the lever [3], and
move it in the direction of the arrow to
remove.
[3]
Figure 7-219
5) Remove the multifeeder holding plate
retaining plate [5], and detach the
separation pad [6].
[6]
Figure 7-219-1
A
B
[1]
[5]
[4]
[5]