Canon GP405 Service Manual page 265

3) Detach the compartment from the deck.
(See p. 8-25.)
4) Disconnect the connector [5], and remove
the five screws [6]; then, detach the deck
lifter motor unit [7].
[5]
[6]
Figure 8-328
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[6]
[7]
CHAPTER 8 PAPER DECK
5. Removing the Lifter Cable (deck
front side plate)
1) Open the compartment, and remove any
paper.
2) Remove the screw, and remove the paper
trailing edge guide plate from inside the
compartment.
3) Push down the sensor lever [1] of the
paper supply position sensor inside the
compartment, and match the left and right
holes in the compartment side plate and
the left and right holes in the lifter; then,
insert two long screwdrivers [2] for
positioning the lifter.
[1]
Figure 8-329
[2]
8-31