Canon GP405 Service Manual page 219

4. Orientation of the Multifeeder Pick-
Up Roller
When mounting the multifeeder pick-up
roller [1], be sure to orient it so that the side
with a cross [2] on the collar is toward the rear.
(rear)
Figure 7-220
5. Orientation of the Multifeeder Paper
Guide Cam
Make adjustments so that the paper guide
plate cam is as indicate in the figure when the
solenoid plate is in contact with the claw of the
control ring.
Screw w/
Lever
hex hole
Paper guide
plate cam
Solenoid plate
Figure 7-221
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[2]
[1]
Gear 1
Control ring
Claw
Gear 2
CHAPTER 7 PICK-UP/FEEDING SYSTEM
6. Attaching the Timing Belt to the
Multifeeder
1) Butt the side guide plates of the
multifeeder against both ends (A; open
state).
2) Move the slide volume to the center (in
the direction of B), and attach the timing
belt to the pulley.
Timing belt Rack plate
B
Pulley
Slide volume
Figure 7-222
7. Adjusting the Rear/Front Registration
Make a copy in Direct, and check to make
sure that the margin along the front of the
image is 2.5 ±1.5 mm.
(-) (+)
2.5 ± 1.5mm
0
2
4
6
8
10
Figure 7-223
A
Pulley
7-57