E. Primary Charging Roller
Cleaning Solenoid
1. Removing the Primary Charging
Roller Cleaning Solenoid
1) Remove the following parts:
•
Drum unit
•
Developing assembly
•
Rear cover
•
Flywheel
•
Power cord mount
•
Composite power supply PCB
•
DC controller PCB
•
Low-voltage PCB
•
Accessories power supply PCB
•
Scanner cooling fan assembly
•
Main drive unit
•
Registration clutch
2) Free the harness, and remove the two
screws [1]; then, detach the harness guide
[2].
[2]
Figure 6-405
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[1]
[1]
CHAPTER 6 IMAGE FORMATION SYSTEM
3) Remove the two screws [3], and detach
the primary charging roller cleaning
solenoid unit [4].
Figure 6-406
4) Disconnect the connector [5], and remove
the two screws [6]; then, detach the
primary charging roller cleaning solenoid
[7].
[5]
[7]
Figure 6-407
2. Adjusting the Position
Adjust the position of the primary
charging roller cleaning solenoid (SL1) so that
the length shown in Figure 6-408 is 4.0 ±0.2
mm.
4.0 ± 0.2mm
Figure 6-408
[3]
[4]
[6]
6-27