Canon GP405 Service Manual page 397

Caution:
1. If bit 4 of the DIP switch (SW5-4) of
the copy data controller is set to OFF,
group control is disabled and the
indication will be as follows:
Figure 12-516
2. If the copier already has a list of IDs
in its memory, they may be shared by
the copy data controller; perform the
following:
Copying the IDs
a) Set the bits of the DIP switch (SW1) of the
copy data controller as follows:
bit
SW1 1, 2
3
Table 12-503
b) Press the switch SW4 of the copy data
controller.
LED5 should turn on instantaneously in
response to a press on the switch.
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Position
ON
OFF
CHAPTER 12 INSTALLATION
c) LED5 turns on to indicate the end of data
copying.
LED5 flashes if copying of data fails.
Press the switch SW4 once again, and see
if LED5 turns on.
The copier cannot deliver paper during
copying operation.
d) Set the bits of the DIP switch SW1 of the
copy data controller as follows.
LED5 should turn off.
bit
SW1
1, 2, 3
Table 12-504
LED1 LED2
LED1 LED2 LED3
SW2
LED4 LED5 LED6
LED5
6 1 6 1
SW1 ON SW5 ON
SW1-3 SW1-2 SW1-1
Figure 12-517
Position
OFF
LED3
SW3
JA1
JB2
JA2
JB1
SW4
SW4
12-39