Canon GP405 Service Manual page 636

CHAPTER 14 TROUBLESHOOTING
<DISPLAY>
Level 1
FEEDSIZE Displays the size of original detected by the feeder.
<ADJUST>
Level 3
DOC-ST Adjusts the original stop position for top separation. Same
as DOC-ST-R.
DOC-ST-R After selecting the item, place a single original on the RDF
original tray, and press the OK key.
When the original has been fed, open the feeder, and take
note of the original on the copyboard glass.
If the original is to the left of the V marking, increase the
setting.
If the original is to the right of the V marking, decrease the
setting.
P-INTL-U Selects sheet-to-sheet distance for top pick-up.
1) Check to make sure that '0' is set to
2) Select the item, and place two originals on the original
3) Press the OK key. The original will be fed and will be
4) Adjust the distance between sheets.
P-INTL-L Adjusts the sheet-to-sheet distance for bottom pick-up.
1) Check to make sure that '1' is set to
2) Select the item, and place two originals on the original
3) Press the OK key. The original will be fed and stopped
4) Measure the distance between sheets.
14-218
Description
e.g., A4, LTR.
Description
COPIER>OPTION>FACE-DOWN.
tray.
stopped on the copyboard glass.
If the distance is small, increase the setting.
If the distance is large, increase the setting.
COPIER>OPTION>FACE-DOWN.
tray.
on the copyboard glass.
If the distance is small, increase the setting.
If the distance is large, decrease the setting.
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
FEEDER
REf.
REf.
Unit: 0.5 mm