Menus - Woodward 723PLUS Technical Manual

723PLUS Digital Marine Control
The 723PLUS has two sets of menus; the Service menus and Configure menus.
The Service menus allow easy access and tuning while the engine is running.
The Configure menus may only be entered if the I/O is shut down, and hence the
engine stopped.
Configure Menus
To access Configure menus, the engine must be shut down. Close the Run/Stop
contact. Press the "." key. The display will show "To select configure, press
enter". Press the ENTER key and the display will show "To shutdown I/O, press
enter". Press the ENTER key and this will allow you into the Configure menus.
If the engine is running during this process, it will be shut down due
to shutting down the I/O of the control.
To move between the menus, use the "Arrow Left" and "Arrow Right" keys. To
move through the set points within a menu, use the "Arrow Up" and "Arrow
Down" keys. Once within a menu, to return to the menu header, press the ESC
key.
To leave the Configure menus press the ESC key. The set points will be
automatically saved when leaving Configure, and the control will automatically
reboot itself.
Service Menus
To access the Service menus press the "Arrow Down" key from the master
screen. To move between menus, and to move through set points within menus,
follow the instructions as for the Configure menus. Also to return to the menu
header, or to leave Service, follow the Configure instructions.
Adjusting Set Points
To adjust a set point, use the "Turtle Up" or the "Rabbit Up" keys to increase the
value, and the "Turtle Down" or "Rabbit Down" keys to decrease the value. The
"Rabbit Up" and "Rabbit Down" keys will make the rate of change faster than the
"Turtle Up" and "Turtle Down" keys. This is useful during initial setup where a
value may need to be changed significantly. Where necessary, to select TRUE,
use either the "Turtle Up" or the "Rabbit Up" keys, and to select FALSE, use the
"Turtle Down" or "Rabbit Down" keys. To increase or decrease the value one unit
at a time, use the "+" (PLUS) or "–" (MINUS) keys.
To obtain an exact value, press the "=" key. Key in the required figure and press
ENTER.
This may be done only if the figure is within 10% of the existing
value.
34

Menus

Manual 26482
Woodward