Electrostatic Discharge Awareness - Woodward 723PLUS Technical Manual

Manual 26482
Battery Charging
Device

Electrostatic Discharge Awareness

Electrostatic
Precautions
Follow these precautions when working with or near the control.
1. Avoid the build-up of static electricity on your body by not wearing clothing
made of synthetic materials. Wear cotton or cotton-blend materials as much
as possible because these do not store static electric charges as much as
synthetics.
2. Do not remove the printed circuit board (PCB) from the control cabinet
unless absolutely necessary. If you must remove the PCB from the control
cabinet, follow these precautions:

Do not touch any part of the PCB except the edges.

Do not touch the electrical conductors, the connectors, or the
components with conductive devices or with your hands.

When replacing a PCB, keep the new PCB in the plastic antistatic
protective bag it comes in until you are ready to install it. Immediately
after removing the old PCB from the control cabinet, place it in the
antistatic protective bag.
Woodward
To prevent damage to a control system that uses an alternator or
battery-charging device, make sure the charging device is turned off
before disconnecting the battery from the system.
Electronic controls contain static-sensitive parts. Observe the
following precautions to prevent damage to these parts:

Discharge body static before handling the control (with power to
the control turned off, contact a grounded surface and maintain
contact while handling the control).

Avoid all plastic, vinyl, and Styrofoam (except antistatic versions)
around printed circuit boards.

Do not touch the components or conductors on a printed circuit
board with your hands or with conductive devices.
To prevent damage to electronic components caused by improper
handling, read and observe the precautions in Woodward manual
82715
, Guide for Handling and Protection of Electronic Controls,
Printed Circuit Boards, and Modules.
723PLUS Digital Marine Control
v