Woodward 723PLUS Technical Manual page 111

Manual 26482
D**CONFIG MINOR ALARMS**
01 MPU 1 FAILED
02 MPU 2 FAILED
03 BOTH MPU FAILED
04 REMOTE SPEED FAILED
05 TORQUE INPUT FAILED
06 RACK POSN INPUT FAILED
07 HIGH ACT ALARM
08 LON CH1 ERROR
09 LON CH2 ERROR
10 LON CH1&2 ERROR
11 PID @ LOW LEVEL
12 OVERSPEED
13 CLUTCH FAIL TO CLOSE
14 ACT MODE (MECH GOV)
15 TORQ DEV ERROR
E**ALARM/SD CONFIGURE**
01 ALARM DELAY TIME
02 OPEN CNT ON MIN ALM
03 OPEN CNT ON MAJ ALM
04 SHUTDOWN WHEN PID@0
05 PID @ ZERO LEVEL
06 PID @ ZERO TIME
07 HIGH ACT ALM LEVEL (%)
08 OVERSPEED SD (RPM)
09 LON ALM DELAY TIME
10 ACT MODE SWITCH DELAY
F**CFIG COM PORT 2
01 PORT 2 ADDRESS
Service Menus
A**DISPLAY 1**
01 ENGINE SPEED (RPM)
02 SPEED REFERENCE (RPM)
03 ACTUATOR COMMAND %
04 ACTUATOR COMMAND (mA)
05 TORQUE INPUT (4-20 mA)
06 TORQUE INPUT %
07 RACK POS INPUT (1–5 Vdc)
08 REMOTE SPD INPUT (1-5 Vdc)
09 BIASED SPD REF
10 ENGINE SPEED MPU#1 (RPM)
11 ENGINE SPEED MPU#2 (RPM)
12 TORQUE OUT – FT/LBS
B**DISPLAY 2**
01 ACT SHUTDOWN
02 ON DYNAMICS 2
03 SPEED CONTROL MODE
04 ON MAX FUEL LIMIT
05 ON START FUEL LIMIT
06 ENGINE OVER SPED?
07 CH1 LON ERROR
08 CH2 LON ERROR
09 USE MASTER SPD REF
10 ON TORQUE SHARING
11 PORT 1 ON HANDHELD
12 PORT 1 ON SERVLINK
13 RESET ALL ALARMS
Woodward
723PLUS Digital Marine Control
Default
#FALSE
#FALSE
#TRUE
#TRUE
#FALSE
#TRUE
#FALSE
#FALSE
#FALSE
#FALSE
#TRUE
#TRUE
#FALSE
#FALSE
#FALSE
Default (Low, High)
#0.5 (0.01, 60.0)
#FALSE
#TRUE
#FALSE
#0.0 (0.0, 100.0)
#10.0 (0.0, 120.0)
#100.0 (0.0, 100.0)
#1400 (1, 2200)
#2.0 (0.1, 60.0)
#4.0 (0.25, 4.0)
Default (Low, High)
#0 (0, 15)
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
Display Only
*FALSE
101