Table of Contents
Advertisement
Using the Equipment
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3-46
All TSs missing at all input Ifs – Select the alarm condition from the drop-
down menu to be activated when all multicast streams (primary and secondary)
are no longer supplying data (Set Alarm / No Alarm).
All TSs missing at all input Ifs (relay mapping) – Place a check mark in the
box to activate relay mapping for TS missing at all input ifs alarm.
Port 2 ARP unresolved – Select the alarm condition from the drop-down menu
to be activated when port 2 cannot resolve its addressing due to unresolved
ARPs (Set Alarm / No Alarm).
Port 2 ARP unresolved (relay mapping) – Place a check mark in the box to
activate relay mapping for Port 2 ARP unresolved alarm.
Header error – Select the alarm condition from the drop-down menu to be
activated when the IP input card detects that there are errors in the headers of
some of the UDP / RTP datagrams it has received (Set Alarm / No Alarm).
Header error (relay mapping) – Place a check mark in the box to activate relay
mapping for header error alarm.
Packet lost – Select the alarm condition from the drop-down menu to be
activated when the IP input card detects that a transport packet has been lost
form the IP encapsulation process (Set Alarm / No Alarm).
Packet lost (relay mapping) – Place a check mark in the box to activate relay
mapping for packet lost alarm.
Port 1 net util – Enter the maximum allowable network utilization (0 to 100%).
This is used to trigger the alarm condition, set above, when exceeded.
Port 1 net util (relay mapping – Place a check mark in the box to activate relay
mapping for network utilization alarm.
Port 2 net util – Enter the maximum allowable network utilization (0 to 100%).
This is used to trigger the alarm condition, set above, when exceeded.
Port 2 net util (relay mapping) – Place a check mark in the box to activate
relay mapping for network utilization alarm.
MDI delay factor – Enter the maximum allowable MDI delay factor This is used
to trigger the alarm condition, set above, when exceeded.
MDI delay factor (relay mapping) – Place a check mark in the box to activate
relay mapping for MDI Delay alarm.
MDI loss rate – Enter the maximum allowable MDI loss rate This is used to
trigger the alarm condition, set above, when exceeded.
MDI loss rate (relay mapping) – Place a check mark in the box to activate relay
mapping for MDI Loss rate alarm.
Option Card SW Fail – Select the alarm condition from the drop-down menu to
be activated when the T2 option card's software fails to boot (Set Alarm / No
Alarm).
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
