Alarm Modes; Generic Alarm Identifiers; Decode Alarm Identifiers; Introduction - Ericsson RX8000 Reference Manual

C.1

Introduction

This section lists the fixed Alarm Identifiers used when the Alarm Mode is configured
to Compatibility Mode.
C.1.1

Alarm Modes

C.1.1.1

Dynamic Mode

The dynamic mode alarm functionality utilizes the next available incrementing
identifier assigned at start-up. These identifiers will change depending on the cards
detected in the unit configuration.
C.1.1.2

Compatibility Mode

The compatibility mode setting uses pre-defined identifiers assigned at startup. This
in-turn allows the identifier of different units to be tracked through the external
control system consistently. These identifiers are listed in the following sections.
C.2

Alarm Identifier Lists

C.2.1

Generic Alarm Identifiers

Table C.1 Generic Alarm Identifiers
Name
No TS Lock
No Primary Input Lock
No Secondary Input Lock
C.2.2

Decode Alarm Identifiers

Table C.2 Decode Alarm Identifiers
Name
Video Not Running
Audio 1 Not Running
Audio 2 Not Running
Audio 3 Not Running
Audio 4 Not Running
EN/LZT 790 0005 R7A
Identifier Description
1000 No valid transport stream is available
on selected input
1001 Primary TS input failure
1002 Secondary TS input failure
Identifier Description
1010 Video decode is not in the running
state
1011 Audio instance 1 is not in the running
state
1012 Audio instance 2
1013 Audio instance 3
1014 Audio instance 4
Alarm Identifiers
C-3