Ericsson RX8000 Reference Manual page 155

•
•
•
•
•
•
•
•
Note: All channels found are displayed in the "Channels Found" drop down list.
3.10.7.8 Status
Main Page
Figure 3.59 Basic Status Displaying in Case of Receiving a DVB-T Stream
Figure 3.60 Basic Status Displaying in Case of Receiving a DVB-T2 Stream
•
EN/LZT 790 0005 R7A
Finishing Frequency – This defines the finishing center frequency for any scan
operation.
Frequency Step – This defines each step taken during the san process (ideally,
this will be channel center frequencies or multiples of them).
Scan for DVB-T – If this is checked the SCAN will include DVB-T modulations.
Scan for DVB-T2 – If this is checked the SCAN will include DVB-T2
modulations.
Scan for 8MHz – 8 MHz channels will be included in the scan.
Scan for 7MHz – 7 MHz channels will be included in the scan.
Scan for 6 MHz – 6 MHz channels will be included in the scan.
Check TS Lock – This checks for a valid lock before scanning.
Card alarm status – This supplies the status of the demodulator card, this can
have the values:
- NO ALARM
Using the Equipment
3-115