Table of Contents
Advertisement
3.11.4.6
Setup
To check for correct setup of the Director system it is recommended that an over air
message is sent to the receiver or population of receivers and confirm that the
receiver reacts to the command. At the head-end, using nCC Director, the typical set
of commands should be sent:
Seconds later, the receiver should have the Over Air Control mode Enabled and
the Over Air Message should display the message text set by the head-end (e.g.
Hello World).
Figure 3.74 Over Air Message Field
Note: The duration of the message can be set at the head-end, it is recommended
The message can also be seen on front panel menu (menu number 5.2.1).
If the message is not seen check the receiver type and Customization Serial
Number (also known as the Unique Hardware ID) at the head end. Also check that
the receiver is tuned to the correct Transport Stream from the head end.
Note: Providing a more detailed description of the Director system is outside the
3.11.4.7
Front Panel
3.11.4.7.1
Over Air Message
This menu displays the Over Air Message sent from the Director head-end.
EN/LZT 790 0005 R7A
•
Configure the receiver's state: Switch to OAC mode
•
Configure the message display: Display message on front panel; Hello
World; 60 seconds
that the duration is set for long enough that the user of the receiver will see
it. The web page will have to be manually refreshed to see the text.
scope of this document. Please contact Ericsson Customer Support for
more information
DIRV5
5.2.1
|OVER AIR MESSAGE
|TEST MESSAGE 1
Using the Equipment
3-155
Advertisement
Table of Contents
