Table of Contents
Advertisement
Using the Equipment
The transport stream after this stage will be routed to the ASI output as a single
stream. The transport stream is also be routed IP Output module as a single stream
or manipulated by the Service Splitting feature.
Note: In this mode it is not possible to remap components from any of the filtered
3.19.3.6
Configuration
From the Output > Filter page of the web browser interface, the Service Filter
Mode must be set to Multi Service.
3.19.3.6.1
Service Selection
Figure 3.172 Services Web Page Showing Multi Service Filtering
To select a service to be filtered:
1. Tick the Filter column.
2. Check box of the service row. You can select up to 22 services in one go.
3. Then, click Apply Changes.
To deselect a service:
1. Just click on the Filter check box of the service that is already selected. New
2. Then, click Apply Changes.
The selections and de-selections can be done at the same time. If the information of
any selected service has not been updated, click Refresh to update it.
3.19.3.6.2
PID Information
When the mouse hovers over the Details hyperlink item, a list of the associated
components are shown in a pop up box.
3-360
services
selections will be shown in red.
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
