Table of Contents
Advertisement
Using the Equipment
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3-44
C/N Margin (min value) – Enter the Carrier-to-Noise margin minimum value in
decibels. This is used to trigger the alarm condition, set above, when exceeded.
C/N Margin (relay mapping) – Place a check mark in the box to activate relay
mapping for C/N Margin exceeded alarm.
SNR (min value)
–
Enter the Signal to Noise Ratio minimum value in decibels.
This is used to trigger the alarm condition, set above, when exceeded
SNR (relay mapping) – Place a check mark in the box to activate relay mapping
for SNR exceeded alarm
IPI Ethernet IF 1 and 2 Down – Select the alarm condition from the drop-down
menu to be activated when both Ethernet inputs lose network connectivity (Set
Alarm /No Alarm).
IPI Ethernet IF 1 and 2 Down (relay mapping) – Place a check mark in the box
to activate relay mapping for Ethernet 1 and 2 down.
IPI Ethernet If 1 and 2 No Data
down menu to be activated when both Ethernet Transport Stream inputs loose
Transport Stream lock (Set Alarm /No Alarm).
IPI Ethernet If 1 and 2 No Data (relay mapping) – Place a check mark in the
box to activate relay mapping for Ethernet input 1 and 2 loss of Transport
Stream alarm.
IPI Ethernet If 1 Down – Select the alarm condition from the drop-down menu
to be activated when Ethernet input port 1 loses network connectivity (Set Alarm
/No Alarm).
IPI Ethernet If 1 Down (relay mapping) – Place a check mark in the box to
activate relay mapping for IPI Ethernet If 1 Down alarm.
IPI Ethernet If 1 No Data – Select the alarm condition from the drop-down menu
to be activated when Ethernet input port 1 loses Transport Stream data lock (Set
Alarm / No Alarm).
IPI Ethernet If 1 No Data (relay mapping) – Place a check mark in the box to
activate relay mapping IPI Ethernet IF 1 No Data alarm.
IPI Ethernet If 1 IP Conflict – Select the alarm condition from the drop-down
menu to be activated when Ethernet input port 1 senses a conflict of IP address
with another device (Set Alarm / No Alarm).
IPI Ethernet If 1 IP Conflict (relay mapping) – Place a check mark in the box
to activate relay mapping for IPI Ethernet If 1 IP Conflict alarm.
IPI Ethernet If 2 Down – Select the alarm condition from the drop-down menu
to be activated when Ethernet input port 2 loses network connectivity (Set Alarm
/No Alarm).
IPI Ethernet If 2 Down (relay mapping) – Place a check mark in the box to
activate relay mapping for Transport Stream loss of lock alarm.
–
Select the alarm condition from the drop-
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
