Table of Contents
Advertisement
Using the Equipment
2. The unit should now be tested for connectivity. To do this, open a DOS window
3. If the unit is successfully connected to the network, some replies should be seen
Note: If no valid replies are seen then steps 1 to 3 should be repeated.
4. The batch file updateallrx8000.bat is supplied with the code package. This
5. Ensure the batch file updateallrx8000.bat is placed on the networked PC in the
6. Using a DOS window, navigate the directories until the directory with the above
7. At the DOS prompt type:
8. The batch file will now prompt the user for the IP address of the unit to be
9. The batch file will now prompt for the board type to be upgraded. This will be
3-388
on the networked PC. At the DOS prompt type:
ping <ip address>
at the DOS prompt, these will be of the form:
reply from <ip address> bytes =32 time = nn TTl =nn
batch file allows the update of code to either flash bank of the RX8000 and also
allows option cards to be upgraded.
same directory as the new image file main.bin and any other option card
software images.
two files is accessible.
Updateallrx8000.bat
upgraded. The IP address of the unit should be entered in the same way as
circled in the example below followed by pressing Enter.
either the Mainboard code or one of the option cards installed on the unit. The
choice is entered in the same way as circled in the example below followed by
pressing Enter.
EN/LZT 790 0005 R7A
Advertisement
Table of Contents
