Honeywell IAQPoint2 User Manual page 1079

Installation
monitor mounting plate
IAQPoint monitor
3
1. Drill a 1 /
16
2. Orient the lateral air holes to face the air flow and insert the
sampling tube into the opening.
3. Affix the octagonal plate to the duct.
4. Place a standard electrical box on the octagonal plate (orient the
box's mounting holes vertically) and affix with two #8 metal screws.
5. Screw the mounting plate onto the electrical box.
6. Connect the wire from the electrical box to the IAQPoint monitor.
7. Connect the power and outputs as shown in Wiring Details.
8. Verify that the sampling tube feeds into the appropriate port on the
back of the IAQPoint monitor. Press the monitor onto the plastic
base (the latches will click).
M-511703
electrical box
in. (3 cm) opening for the sampling tube.
The IAQPoint with the temperature and humidity sensor
option must be duct mounted using a different method. See
following page for further details.
IAQPoint User Manual
Honeywell
Installation Instructions
duct
octagonal plate
Introduction
15