Use And Calibration - Honeywell IAQPoint2 User Manual

Use and Calibration

Points Definitions
Points Definitions
Point 01 CTLR ADDRESS
This point contains the device address. The default value is 99
(Backdoor address), however, the initial value is set on the
hardware (Dip Switch SW3). The detector always answers to
adress 99. This point cannot be changed by software (P1
Command) and a reset of the unit is needed to update the
value of this register (reset can be d901Tone with a P1
command).
Point 02 APPLICATION
This point shows the current application number for this
product.
Point 03 SENSOR TYPE
This point shows the gas type detected by the detector.
Point 04 GAS CONC
The gas concentration can be read with this point. It shows the
current gas concentration of its surveillance area.
Point 05 FULL SCALE
This status point shows the maximum limit (concentration) of
the detection range.
Point 06 GAS SPAN
This point contains the concentration of the gas used for the
span calibration.
Point 7-10ALARM PNT
These points specify alarm levels. Refer to Digital Inputs on
page 17 for more detail.
Point 11 SENSOR TEMP
Shows the temperature inside the detector.
30
Use and Calibration
901T User Manual