Adding A New Sensor - Honeywell IAQPoint2 User Manual

• Press enter to select the sensor. The screen displays the sensor gas
type and its address. Use the arrows to scroll to the address desired
(between 1 and 20) and press enter to confirm.
The sensor's address has been changed.

Adding a new Sensor

This menu lets users add new sensors (to expand the network or to
replace an expired sensor).
• Scroll to the Scan SD menu option and press enter to select.
The device searches for any new sensor and assigns the new sensor the
first available address. The screen displays a wait message while the
device searches for the sensor.
When the device has found the sensor, it displays the sensor device
address (its position in the 301EM) and its firmware version.
When adding new sensors, it is important to add one sensor
at a time to ensure proper address assignment.
301EM User Manual
Programming and Calibration
Configuring a Sensor
33