EOL Network Diagram
The End of Line, or EOL, wiring of a unit on a network means that there is
no other unit connected to the network beyond this point. The unit is,
thus, End of Line and there are no further connections to make.
A+
B-
V+
V-
The unit that is destined to be End-Of-Line is preset at the factory and
labeled EOL. Simply remove the jumper from the resistor pins to remove
the EOL termination from the unit or place the jumper over the first two
resistor pins to make the unit the EOL, as shown in the following drawing.
901T
Power in
EOL Positions
901T User Manual
Communication in
EOL resistor
S
S
-
B
A
+
V- OUT
V+ OUT
V-
V+
Disabled
R
RC
Wiring Details
Wiring Requirements
shield
J7
EOL
J1
15