HP A3100-8 v2 SI Configuration Manual page 170

Figure 56 Network diagram for many-to-one VLAN mapping configuration
Configuration procedure
# Create the CVLANs and SVLANs.
<SwitchA> system-view
[SwitchA] vlan 2 to 6
[SwitchA] vlan 101 to 102
# Configure uplink policies p1 and p2 to transmit all services of one customer in a unique SVLAN.
[SwitchA] traffic classifier c1 operator or
[SwitchA-classifier-c1] if-match customer-vlan-id 1 to 3
[SwitchA-classifier-c1] traffic classifier c2 operator or
[SwitchA-classifier-c2] if-match customer-vlan-id 4 to 6
[SwitchA-classifier-c2] quit
[SwitchA] traffic behavior b1
[SwitchA-behavior-b1] remark service-vlan-id 101
[SwitchA-behavior-b1] traffic behavior b2
[SwitchA-behavior-b2] remark service-vlan-id 102
[SwitchA-behavior-b2] quit
[SwitchA] qos policy p1
[SwitchA-policy-p1] classifier c1 behavior b1 mode dot1q-tag-manipulation
[SwitchA-policy-p1] quit
[SwitchA] qos policy p2
[SwitchA-policy-p2] classifier c2 behavior b2 mode dot1q-tag-manipulation
[SwitchA-policy-p2] quit
# Configure customer-side port Ethernet 1/0/1 as a trunk port, assign the port to CVLANs 1 to 3 and
SVLAN 101, and apply uplink policy p1 to the incoming traffic of the port.
[SwitchA] interface ethernet 1/0/1
[SwitchA-Ethernet1/0/1] port link-type trunk
[SwitchA-Ethernet1/0/1] port trunk permit vlan 1 2 3 101
[SwitchA-Ethernet1/0/1] qos apply policy p1 inbound
[SwitchA-Ethernet1/0/1] quit
163