Configuring Mac Information Mode; Configuring The Interval For Sending Syslog Or Trap Messages; Configuring The Mac Information Queue Length - HP A3100-8 v2 SI Configuration Manual

To do...
Enter system view
Enter Layer 2 Ethernet interface
view
Enable MAC Information on the
interface
NOTE:
To enable MAC Information on an Ethernet interface, enable MAC Information globally first.

Configuring MAC Information mode

Follow these steps to configure MAC Information mode:
To do...
Enter system view
Configure MAC Information mode

Configuring the interval for sending Syslog or trap messages

To prevent Syslog or trap messages from being sent too frequently, you can set the interval for sending
Syslog or trap messages.
Follow these steps to set the interval for sending Syslog or trap messages:
To do...
Enter system view
Set the interval for sending Syslog
or trap messages

Configuring the MAC Information queue length

To avoid losing user MAC address information, when the buffer that stores user MAC address
information reaches capacity, the user MAC address information in the buffer is sent to the monitor end
in the network, even if the timer set for sending MAC address monitoring Syslog or trap messages has not
expired yet.
Follow these steps to configure the MAC Information queue length:
To do...
Enter system view
Configure the MAC Information
queue length
Use the command...
system-view
interface interface-type
interface-number
mac-address information enable
{ added | deleted }
Use the command...
system-view
mac-address information mode
{ syslog | trap }
Use the command...
system-view
mac-address information interval
interval-time
Use the command...
system-view
mac-address information
queue-length value
24
Remarks
—
—
Required
Disabled by default.
Remarks
—
Optional
trap by default.
Remarks
—
Optional
One second by default.
Remarks
—
Optional
50 by default.