Many-To-One Vlan Mapping Configuration Example - HP A3100-8 v2 SI Configuration Manual

[SwitchA-behavior-b2] traffic behavior b3
[SwitchA-behavior-b3] remark service-vlan-id 301
[SwitchA-behavior-b3] traffic behavior b4
[SwitchA-behavior-b4] remark service-vlan-id 102
[SwitchA-behavior-b4] traffic behavior b5
[SwitchA-behavior-b5] remark service-vlan-id 202
[SwitchA-behavior-b5] traffic behavior b6
[SwitchA-behavior-b6] remark service-vlan-id 302
[SwitchA-behavior-b6] quit
[SwitchA] qos policy p1
[SwitchA-policy-p1] classifier c1 behavior b1
[SwitchA-policy-p1] classifier c2 behavior b2
[SwitchA-policy-p1] classifier c3 behavior b3
[SwitchA-policy-p1] classifier c4 behavior b4
[SwitchA-policy-p1] classifier c5 behavior b5
[SwitchA-policy-p1] classifier c6 behavior b6
[SwitchA-policy-p1] quit
[SwitchA] qos apply policy p1 global inbound
# Configure customer-side port Ethernet 1/0/1 as a trunk port, assign the port to CVLANs 1 to 3 and
SVLANs 101, 201, and 301, and enable selective QinQ on the port.
[SwitchA] interface ethernet 1/0/1
[SwitchA-Ethernet1/0/1] port link-type trunk
[SwitchA-Ethernet1/0/1] port trunk permit vlan 1 2 3 101 201 301
[SwitchA-Ethernet1/0/1] qinq enable downlink
[SwitchA-Ethernet1/0/1] quit
# Configure customer-side port Ethernet 1/0/2 as a trunk port, assign the port to CVLANs 4 through 6
and SVLANs 102, 202, and 302, and enable selective QinQ on the port.
[SwitchA] interface ethernet 1/0/2
[SwitchA-Ethernet1/0/2] port link-type trunk
[SwitchA-Ethernet1/0/2] port trunk permit vlan 4 5 6 102 202 302
[SwitchA-Ethernet1/0/2] qinq enable downlink
[SwitchA-Ethernet1/0/2] quit
# Configure network-side port Ethernet 1/0/3 as a trunk port, and assign it to all SVLANs.
[SwitchA] interface ethernet 1/0/3
[SwitchA-Ethernet1/0/3] port link-type trunk
[SwitchA-Ethernet1/0/3] port trunk permit vlan 101 201 301 102 202 302

Many-to-one VLAN mapping configuration example

Network requirements
As shown in
Each home is offered PC, VoD, and VoIP services, and connects to a wiring-closet switch through the
•
home gateway.
To obtain traffic statistics for each home on the campus switch that is located at the aggregation
•
layer, map the outgoing traffic from the same home to a specific VLAN on the wiring-closet switch.
Figure 56:
162