Assigning An Access Port To A Vlan - HP A3100-8 v2 SI Configuration Manual

Assigning an access port to a VLAN

You can assign an access port to a VLAN in VLAN view, interface view (including Ethernet interface view
and Layer 2 aggregate interface view), or port group view.
Follow these steps to assign one or multiple access ports to a VLAN in VLAN view:
To do...
Enter system view
Enter VLAN view
Assign one or a group of access
ports to the current VLAN
Follow these steps to assign an access port (in interface view) or multiple access ports (in port group view)
to a VLAN:
To do...
Enter system view
Enter interface
view (including
Ethernet interface
view, Layer 2
aggregate
interface view) or
port group view
Configure the link type of the port or
ports as access
Assign the current access port(s) to a
VLAN
NOTE:
Before you assign an access port to a VLAN, create the VLAN.
•
In VLAN view, you can assign only Layer 2 Ethernet interfaces to the current VLAN.
•
• After you configure a command on a Layer 2 aggregate interface, the system starts applying the
configuration to the aggregate interface and its aggregation member ports. If the system fails to do that
on the aggregate interface, it stops applying the configuration to the aggregation member ports. If it
fails to do that on an aggregation member port, it skips the port and moves to the next port.
Use the command...
system-view
vlan vlan-id
port interface-list
Use the command...
system-view
Enter Ethernet interface interface-type
interface view interface-number
Enter Layer 2
interface bridge-aggregation
aggregate
interface-number
interface view
Enter port port-group manual
group view port-group-name
port link-type access
port access vlan vlan-id
Remarks
—
Required
If the specified VLAN does not exist, this
command creates the VLAN first.
Required
By default, all ports belong to VLAN 1.
99
Remarks
—
Required
Use either command.
•
In Ethernet interface view, the
subsequent configurations
apply to the current port.
•
In port group view, the
subsequent configurations
apply to all ports in the port
group.
•
In Layer 2 aggregate interface
view, the subsequent
configurations apply to the
Layer 2 aggregate interface
and all its member ports.
Optional
The link type of a port is access by
default.
Optional
By default, all access ports belong
to VLAN 1.