Download Print this page

HP A3100-8 v2 SI Configuration Manual: Configuring Gvrp Functions

A3100 v2 switch series layer 2 - lan switching.
Hide thumbs

Advertisement

Task

Configuring GVRP functions

Configuring GARP timers
NOTE:
GVRP configuration made in Ethernet interface view or Layer 2 aggregate interface view takes effect on
the current interface only. GVRP configuration made in port group view takes effect on all the member
ports in the group.
GVRP configuration made on a member port in an aggregation group takes effect only after the port is
removed from the aggregation group.
Configuring GVRP functions
Before enabling GVRP on a port, you must enable GVRP globally. In addition, you can configure GVRP
only on trunk ports, and you must assign the involved trunk ports to all dynamic VLANs.
Follow these steps to configure GVRP functions on a trunk port:
To do...
Enter system view
Enable GVRP globally
Enter Ethernet
interface view,
Layer 2
aggregate
interface view,
or port group
view
Configure the link type of the ports as trunk
Assign the trunk ports to all VLANs
Enable GVRP on the ports
Configure the GVRP registration mode on the
ports
Enter Ethernet interface
view or Layer 2
aggregate interface view
Enter port group view
Remarks
Required
Optional
Use the command...
system-view
gvrp
interface interface-type
interface-number
port-group manual
port-group-name
port link-type trunk
port trunk permit vlan all
gvrp
gvrp registration { fixed |
forbidden | normal }
129
Remarks
––
Required
Globally disabled by
default.
Required
Perform either of the
commands.
Required
Access by default.
Required
By default, a trunk port is
assigned to VLAN 1
only.
Required
Disabled by default.
Optional
normal by default.

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: