Configuring A Remote Destination Group (On The Destination Device) - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter interface view.
3. Configure the current port as
the egress port.
NOTE:
A mirroring group contains only one egress port.
•
A source port of an existing mirroring group cannot be configured as an egress port.
•
Configuring the remote probe VLAN for the remote source group
Before configuring a remote probe VLAN, create a static VLAN that will serve as the remote probe VLAN
for the remote source group.
Configuration restrictions and guidelines:
1.
A VLAN can serve for only one mirroring group.
When a VLAN is configured as a remote probe VLAN, you must remove the remote probe
VLAN configuration before deleting the VLAN.
When you remove the configuration of a remote probe VLAN, an active mirroring group
becomes inactive.
When a VLAN is configured as a remote probe VLAN, use the remote probe VLAN for port
mirroring exclusively. Do not create a VLAN interface for the VLAN or configure any other
features for the VLAN.
The remote mirroring groups on the source device and destination device must use the same
remote probe VLAN.
Configuration procedure:
2.
To configure the remote probe VLAN for the remote source group:
Step
1. Enter system view.
2. Configure the
remote probe
VLAN.
Configuring a remote destination group (on the destination
device)
To configure a remote destination group, make the following configurations on the destination device:
Creating a remote destination group
Command
system-view
interface interface-type
interface-number
mirroring-group group-id
monitor-egress
Command
system-view
mirroring-group group-id
remote-probe vlan rprobe-vlan-id
83
Remarks
N/A
N/A
By default, a port does not serve as the
egress port for any remote source
group.
Remarks
N/A
By default, no remote probe VLAN is
configured for a remote source group.