Copy Operator; F1) Afm Algorithm (Form) - Yamaha SY77 Operating Manual

VOICE EDIT MODE
Source Voice Select: Specify the memory
(internal, card, preset 1 or preset 2), the bank
A-D, and the number 1-16 of the voice from
which you want to copy element data.
Source Voice: The number and name of the
selected source voice is displayed.
Source Element Type: The type (AWM or
AFM) of each element in the selected voice is
displayed.
AFM ELEMENT DATA
Summary: While editing the parameters for oper-
ator EG or Output, you can copy EG and Output
data from one operator to another.
Procedure:
From: AFM element job 3 or 4
Press: COPY
Select: the data type, source operator, and
destination operator
To execute: the copy operation press F8 (Go)
AFM ELEMENT DATA
Summary: Select the Algorithm and specify feed-
back routings between operators.
Procedure:
From: AFM Element job directory (JUMP #230)
Select: job 01:Algrthm., and press (JUMP #231)
F1 (Form)
Specify: the algorithm number, and feedback
sources and destinations
1 1 8

Copy operator

(JUMP #236-242)

1. (F1) AFM algorithm (Form)

Destination Element Number: Specify the ele-
ment 1-4 of the selected Source Voice which you
want to copy into the currently edited element.
The type (AWM or AFM) of the selected ele-
ment will be displayed in the Element Type line
above. The selected source element must be the
same type as the currently edited element. If
not, the bottom line will show "Element type
mismatch!"
After specifying the source voice and element, press
F8 (Go). The display will ask "Are you sure?". If
you are sure you want to copy the element data then
press YES, and the data will be copied.
Data Type: Select one of the following types of
data to be copied.
EG&OUTPUT: Envelope generator, output level
and scaling
EG: Envelope generator
OUTPUT: Output level and scaling
Source: The specified data will be copied from
this operator.
Destination: The specified data will be copied to
this operator.
Remarks: It is often the case that many or all oper-
ators in a voice have similar settings, especially
for EG parameters. In such cases you can save
time by setting the average EG for the voice on
one operator, and then copying it to the others.
JUMP #231