Security Function Of The Robot Controller (Password Setup) - Mitsubishi R56TB Instruction Manual

16.7.

Security function of the robot controller (Password Setup)

It is possible to forbid accessing the robot programs, parameters and files in the robot controller.
The security function can be achieved by setting the password to the robot controller. This function can be used
with Version 3.0 or later of this software. And the software version of the robot controller which can be used is as
follows.
CR750-D/CRnD-700
CR750-Q/CRnQ-700
The function that the password can be set is as follows. It is possible to setup the password to access of the
program, parameters, and files individually. The factory default setting of "Password Setup" is off.
Type
・ Writing the programs.
Program
・ Reading the programs.
・ Copying the programs.
・ Renaming the programs.
・ Deleting the programs.
・ Writing the position data for SQ Direct.
・ Reading the position data for SQ Direct.
･ Deletion of all robot programs.
・ Writing the parameters.
Parameter
・ Position repair function.
･ Restore the origin data.
･ Restoring the program information
・ Backup
File
・ Restore
・ Position repair function
Tap [Password Setup] button (<a>) on Maintenance menu. The Password Setup window appears.
Maintenace menu
When the security function has been turned on in the controller, the mark
of the item to which access is forbidden.
for example ：
Controller S/W Ver. of the controller
Ver.S3 or later
Ver.R3 or later
Table Function that access is limited.
Limited functions
< >
It is possible to read the parameters
from the robot controller.
It is not possible to write the revision
parameter created by "Position repair
function" in the robot controller.
Program information
restored though < Write the task slot#
> error is displayed when program
information is restored before this
software version 1.8 or earlier.
Password Setup
is displayed in the left of the button
137
Remarks
is correctly