Contents Of The Structural Equipment; Robot Arm - Mitsubishi MELFA RV-6S Series Standard Specifications Manual

1General configuration

1.2 Contents of the structural equipment

1.2.1 Robot arm

The list of structural equipment is shown in
Vertical six-axis
multiple-jointed type
RV-6S/6SL/6SC/6SLC
*Refer to Page 6, "2.1.1 Standard
specifications" for ditails on the
specifications.
Solenoid valve set
(Hand output cable is attached)
<Sink type/Source type>
・ 1 set: 1S-VD01-02/1S-VD01-02E
・ 2 set: 1S-VD02-02/1S-VD02-02E
・ 3 set: 1S-VD03-02/1S-VD03-02E
・ 4 set: 1S-VD04-02/1S-VD04-02E
Hand output cable
・ 1S-GR35S-01 (4sets)
Hand input cable
・ 1S-HC25C-01
Hand curl tube
・ 1 set: 1E-ST0402C
・ 2 set: 1E-ST0404C
・ 3 set: 1E-ST0406C
・ 4 set: 1E-ST0408C
Fig.1-1 ： Structural equipment (Robot arm)
Contents of the structural equipment
1-2
Fig. 1-1.
Machine cable
(Standard product: 7m(CR3-535M) accessory,
5m(CR2B-574) attachment)
Machine cable: CR2B-574 only
(Fixed type: 2m)
・ 1S-02CBL-01
Machine cable extension
Fixed type:
・ 1S- □□ CBL-01
Flexed type:
・ 1S- □□ LCBL-01
Note1) □□ refer the length.
Refer to Table 1-1
Note2) Extend by adding to the arm side of the
standard accessory cable (for fastening).
for datails.
Stopper for changing the operating range
of the J1 axis
・ Stopper part: 1S-DH-02
*This must be installed by the customer.
［Caution］
Standard configuration
equipment
Special shipping
specifications
Option
Prepared by customer