17.4.21. Ethernet
You can set robot controller Ethernet information.
This function can be used with Version 3.2 or later of this software.
Select the device to edit and double tap. A screen is displayed for setting a variety of device information.
If you select [MELFA-3D Vision] or [Network Vision Sensor (2D)] at [Auto configuration], the default value
corresponding to each device is set to items below [Mode].
CAUTION
Using a CRn-500 series robot controller
When using Ethernet with a CRn-500 series robot controller, the "Ethernet interface" option
is required.
171