Table of Contents
Advertisement
7462
ADF solenoid assembly removal
1. Remove the ADF cover, front. See
2. Remove the pick roll position cam assembly spring from the cam shaft lever.
3. Disconnect the solenoid wire harness.
4. Remove the two screws (A) securing the solenoid bracket assembly to the frame of the ADF unit
assembly.
5. Remove the ADF solenoid assembly.
Sensor (ADF top door interlock) removal
1. Remove the ADF cover, rear assembly. See
2. Remove the feed motor bracket assembly. See
page
4-77.
3. Disconnect the sensor harness from sensor.
4. Remove the sensor (ADF top door interlock) bracket screw (A).
5. Remove the bracket with the sensor (ADF top door interlock).
6. Detach the sensor (ADF top door interlock) from the bracket by squeezing the clip (B) and removing the
sensor.
4-80
Service Manual
"ADF cover, front removal" on page
"ADF cover, rear removal" on page
"ADF feed drive motor assembly removal" on
B
A
4-64.
4-65.
Previous
Next
Go Back
Advertisement
Table of Contents
