Table of Contents
Advertisement
7462
Scanner unit assembly removal (MB790)
Warning: When replacing any of the following components:
•
Scanner interface card assembly
•
System card assembly
•
Scanner unit assembly
Only replace one component at a time. replace the required component and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one or the printer will
be rendered inoperable.
These components can be used as a method of troubleshooting as long as the machine is booted into diagnostic
mode or is operating in diagnostic mode. Once a component has been installed in a machine and powered up
into user mode, it cannot be used in another machine. It must be returned to the manufacturer.
1. Remove the ADF unit assembly. See
2. Remove the side cover, left. See
3. Remove the scanner controller card cage cover.
4. Disconnect the CCD and ribbon cable harnesses.
5. Remove the three screws (A) from the right side of the scanner support.
6. Remove the three screws (B) from the left side of the scanner support.
B
7. Slide the flatbed scanner to the rear, and remove.
4-96
Service Manual
"ADF unit assembly removal (MB790)" on page
"Side cover, left removal (MB790)" on page
4-85.
4-123.
A
Previous
Next
Go Back
Advertisement
Table of Contents
